Update procedures

Regular Update for base and mobile

1. Open web interface (see Configuration / Web Interface for details)
2. Drag update file to browser dropzone in the "Home" section of the web interface
3. Wait for update to complete and for the device to automatically reboot.
4. Make sure the device rebooted to the new software version (check software version before and after update)
5. Power cycle the device another time

Full Image (Factory-Reset) Update (BASE-00002 and MOBILE-00002 only)

1. Use the provided factory reset USB Stick for the corresponding device type (MOBILE/BASE)
2. Insert the USB Stick in the USB Port located on the right side of the connectors
3. Power on the device
4. The first led should start to light up green (could take a few seconds)
5. After completion (expected duration around 20 minutes) all three leds should light up green
6. Remove the USB Stick and perform a power cycle
7. Continue with First Operation / Commissioning